English
Italiano 
APC – Anodizing Process Computer
APC – Anodizing Process Computer
APC
- Automatic survey of the surface to be anodized
- Presetting of anodizing current density
- Presetting of the requested number of microns
- Automatic printout of anodizing parameters
Pulse Rectifier for Anodizing
Pulse Rectifier for Anodizing
With the use of pulse rectifiers, the oxide quality is better than the one obtained with a conventional rectifier, as proved by the tests on abrasion, efficiency (ISO 3210) and corrosion (Kesternich).
So it is possible (without disadvantages) to work with a current density higher than conventional rectifiers. Thus the use of pulse rectifiers gives a benefit of 20- 25% time saving compared with the conventional ones.
Anodic Bar and Pneumatic Piston
Anodic Bar and Pneumatic Piston
With all anodizing plants it is obviously desirable to introduce the current into the work being anodized with the minimum power losses, and apart from bus-bar, flight bar and jig design, this means good design of the contact system between the bus-bar and the flight bar or work rail.
To carry the current to the anodic bar on anodizing and electrocoluring tanks special pneumatic cylinders with magnetic contact are used.
ITCG
ITCG
Successful anodizing depends upon the ability to maintain uniform conditions throughout the anodizing cycle and to rapidly remove the produced heat. This means that the capacity of the refrigeration system must always exceed the maximum heat evolution of the anodizing bath plus eventual heat gain from the atmosphere.
For cooling the anodizing baths heat exchangers and circulation pumps suitable for acid solution are used.
TECHNO-RAM
TECHNO-RAM
You can choose up to 6 versions for every model, on the basis of the maximum room temperature in which it will be installed.
This temperature can vary from about 38° C to 50°C, while the minimum temperature is 5° C. Versions can be requested for environments of -10° C or -20° C.
TECHNO-RWM
TECHNO-RWM
The use of top brand semi-hermetic compressors provides a guarantee of reliability and permits maintenance of the compressor heads and cylinders. The use of these compressors with generously sized evaporators and condensers permits to obtain optimum energy efficiency.
read more